RS-360 is a brushed DC motor series for OEM equipment. Compare the installation dimensions and published configurations, then confirm the shaft, winding and loaded working point for your assembly.
Confirm the full model code, selected drawing and operating requirements for your OEM order.
| Motor Length: | 32.5mm(Excluding the Shaft) |
| Motor Diameter: | 27.7mm(Add Magnet Shield Ring:29.5mm Max) |
| Shaft Length: | Custom |
| Shaft Diameter: | 2.3mm |
| Shaft Type: | Round, D-Cut, Knurling, Thread, Ribbing, etc. |
| Voltage: | 0-36V |
| Speed: | 2000-30000RPM |
| Torque: | 0-0.05N.m |
The broad voltage, speed and torque ranges in this legacy source block describe historical customization references. They are not the nominal ratings of one winding, a continuous-duty operating envelope, or a promise that every value or combination is available. Use the complete selected configuration and its agreed test conditions for an order.
| MODEL | VOLTAGE | NO LOAD | AT MAXIMUM EFFICIENCY | STALL | |||||||||
| OPERATING RANGE | NOMINAL | SPEED | CURRENT | SPEED | CURRENT | TORQUE | OUTPUT | EFF | CURRENT | TORQUE | |||
| rpm | A | rpm | A | g-cm | mN-m | W | % | A | g-cm | mN-m | |||
| HRS-360P-4254 | 4.5 - 9.0 | 5.0V CONSTANT | 9800 | 0.28 | 8150 | 1.13 | 45 | 4.41 | 3.76 | 66.5 | 5.3 | 267 | 26.17 |
| HRS-360P-31049 | 6.0 - 12.0 | 12.0V CONSTANT | 12000 | 0.2 | 9760 | 0.9 | 69 | 6.76 | 6.91 | 63.9 | 4 | 370 | 36.26 |
Data is configuration-specific. Confirm the selected winding or gear ratio, test supply, loaded working point and drawing revision before ordering. Maximum-efficiency or stall values are separate reference conditions.
Legacy range note: broad voltage, speed and torque figures below are historical customization references, not the nominal rating or confirmed available operating range of one selected motor. Check the complete winding/configuration and its test conditions.
A model name is the starting point. Share the operating conditions and drawing so the electrical and mechanical configuration can be reviewed together.
Send the complete motor or winding code, supply voltage, loaded speed and torque, duty cycle, installation drawing and expected quantity. Include the shaft, mounting and terminal requirements for your OEM assembly.
Use the complete winding code and matching drawing. Motors with the same series name can have different windings, shaft details and operating points; confirm the selected version before sample evaluation.
Confirm the selected model code, drawing revision and acceptance requirements, then evaluate the sample in the intended equipment and operating conditions.
Compare winding references, shaft dimensions and mounting details for your OEM equipment.
Details to confirm
Compare winding references, shaft dimensions and mounting details for your OEM equipment.
Compare winding references, shaft dimensions and mounting details for your OEM equipment.
Send your preferred model or the working point, installation drawing and expected quantity.
A drawing, reference motor or application brief is a useful starting point.
Open the full inquiry page →Tell us about your equipment and the motor you need.
